Cisco 300-206 Exam Practice Questions

Your hard work and authenticity of Cisco 300-206 exam questions by DumpsSchool can take you towards success in the CCNP Security 300-206 certification exam.

Try it Latest DumpsSchool 300-206 Exam dumps. Buy Full File here: (430 As Dumps)

Download the DumpsSchool 300-206 braindumps from Google Drive: (FREE VERSION!!!)

Question No. 1

Which three types of multicast packets are controlled by using storm control? (Choose three )

Answer: A, C, F

Question No. 2

Which type of authentication and encryption does SNMPv3 use at the authNoPriv sec rity level?

Answer: F

Question No. 3

Which three Cisco ASA configuration commands are used to enable the Cisco ASA to log only the debug output to syslog? (Choose three.)

Answer: A, B, E

Question No. 4

Where do you apply a control plane services policy to implement Management Plane Protection on a Cisco Router?

Answer: B

Question No. 5

What are two reasons for implementing NIPS at enterprise Internet edges? (Choose two.)

Answer: C, D

Question No. 6

An attacker has gained physical access to a password protected router. Which command will prevent access to the startup-config in NVRAM?

Answer: A

Question No. 7

What can an administrator do to simultaneously capture and trace packets in a Cisco ASA?

Answer: B

Question No. 8

Which technology can drop packets with a spoofed source address Instead of forwarding them?

Answer: C

Question No. 9

Refer to the exhibit.

Which statement about this access list is true?

Answer: A

ASA 9.0(1) code introduced the Unified ACL for IPv4 and IPv6. ACLs now support IPv4 and IPv6 addresses. You can even specify a mix of IPv4 and IPv6 addresses for the source and destination. The any keyword was changed to represent IPv4 and IPv6 traffic. The any4 and any6 keywords were added to represent IPv4-only and IPv6-only traffic, respectively. The IPv6-specific ACLs are deprecated. Existing IPv6 ACLs are migrated to extended ACLs.

Question No. 10

An engineer is using Cisco Security Manager and is using default ports configuration. What port must be open to connect the Cisco Security Manager Client to an ASA?

Answer: D

300-206 Dumps Google Drive: (Limited Version!!!)

Exam Vendor: Cisco dumps