Our Huawei Certified Network Professional Transmission H31-321 exam practice software continuously assesses your knowledge and determines when you are ready to pass your Huawei H31-321 exam. Our ITsecurityexams’s Huawei H31-321 exam dumps material can assess if there is a gap between your knowledge. We at ITsecurityexams present you latest Huawei H31-321 exam questions with a focused training module that gets you to pass the H31-321 certification Exam.
|Full Exam Name||HCNP-MSTP Transmission|
|Certification Name||Certified Network Professional Transmission|
♥ 2018 Valid H31-321 Exam Questions ♥
H31-321 exam questions, H31-321 PDF dumps; H31-321 exam dumps: H31-321 Dumps (140 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)
Latest and Most Accurate Huawei H31-321 Exam Questions:
If equipment power is configured with 1+1 protection you can replace the PIU board without cutting
off the supply from the DC power distribution unit.
Which of the following bytes cannot be processed in pass-through mode on an ADM site using OptiX
You can change the VC-12 numbering policy by configuring related parameters on the U2000.
Which of the following about the SSM protocol are true?
A. After the SSM protocol is disabled, the clock network can be unidirectional but cannot adopt a ring
B. After the standard SSM protocol is enabled, the clock network can be bidirectional but cannot
adopt a ring topology.
C. After the extended SSM protocol is enabled, the clock network can be bidirectional and adopt a
ring topology, which can be intersecting or tangent with other networks.
D. The SSM protocol has little to do with clock networks.
Two SNCP rings are intersected. Which of the following statements is true about inter-ring service
A. Configure one unidirectional SNCP service pair on each intersecting node.
B. Configure two unidirectional SNCP service pairs on each intersecting node.
C. Configure four unidirectional SNCP service pairs on each intersecting node.
D. Do not configure any SNCP protection group on each intersecting node.
Latency of store-and-forward equipment is the difference between the time the first bit of a data
frame enters the equipment and the time the first bit exits the equipment.
New Updated H31-321 Exam Questions H31-321 PDF dumps H31-321 practice exam dumps: https://www.dumpsschool.com/H31-321-exam-dumps.html