ICND1 Cisco 100-105 Exam Questions

very your basic networking knowledge. The 100-105 exam checks your abilities of basic networking. You can pass this exam by using DumpsSchool 100-105 exam dumps which carry useful about of network fundamentals, LAN switching technologies, routing technologies, and infrastructure services.

Try it Latest DumpsSchool 100-105 Exam dumps. Buy Full File here: https://www.dumpsschool.com/100-105-exam-dumps.html (671 As Dumps)

Download the DumpsSchool 100-105 braindumps from Google Drive: https://drive.google.com/file/d/1YLDRPm84W1RkVrjNnADi9q8r6hJ4f6-e/view (FREE VERSION!!!)

Question No. 1

Which two statements about RIPv2 are true? (Choose two)

Answer: A, C

Question No. 2

Which two pieces of information can be shared with LLDP TLVs? (Choose two)

Answer: A, B

TLV advertises a single type of information such as its device ID, type or management addresses.

Question No. 3

The internetwork shown in the diagram is experiencing network connectivity problems.

What is the cause of the problem?

Answer: D

Question No. 4

Refer to the exhibit.

The two connected ports on the switch are not turning orange or green. What would be the most effective steps to troubleshoot this physical layer problem? (Choose three.)

Answer: B, D, F

The ports on the switch are not up indicating it is a layer 1 (physical) problem so we should check cable type, power and how they are plugged in.

Question No. 5

Which two security appliances will you use in a network? (Choose two.)

Answer: B, E

Question No. 6

Refer to the topology and partial configurations shown in the exhibit.

The network administrator has finished configuring the NewYork and Sydney routers and issues the command ping Sydney from the NewYork router. The ping fails. What command or set of commands should the network administrator issue to correct this problem?

Answer: E

The IP addresses on the two Serial interfaces of two routers are not in the same subnet so they could not recognize each other and the ping failed. Therefore we must correct the IP address of one of the router so that they are in the same subnet.

Question No. 7

Which two of these statements are true of IPv6 address representation? (Choose two.)

Answer: B, C

A single interface may be assigned multiple addresses of any type (unicast, anycast, multicast).

Every IPv6-enabled interface must contain at least one loopback and one link-local address.

Optionally, every interface can have multiple unique local and global addresses.

IPv6 host addresses can be assigned in multiple ways:

Static configuration

Stateless autoconfiguration

DHCPv6

When IPv6 is used over Ethernet networks, the Ethernet MAC address can be used to generate the 64-bit interface ID for the host. This is called the EUI-64 address.

Since MAC addresses use 48 bits, additional bits must be inserted to fill the 64 bits required.

100-105 Dumps Google Drive: (Limited Version!!!)
https://drive.google.com/file/d/1YLDRPm84W1RkVrjNnADi9q8r6hJ4f6-e/view

Related Certification: https://www.dumpsschool.com/ccna-routing-switching-questions.html