Our HP Storage Solutions Architect HPE0-J79 exam practice software continuously assesses your knowledge and determines when you are ready to pass your HPE0-J79 exam. Our ITsecurityexams’s Architecting Multi-Site HPE Storage Solutions HPE0-J79 exam dumps material can assess if there is a gap between your knowledg. We at ITsecurityexams present you latest HPE0-J79 exam questions with a focused training module that gets you to pass the HPE0-J79 certification Exam.
♥♥ 2018 NEW RECOMMEND HPE0-J79 Exam Questions ♥♥
HPE0-J79 exam questions, HPE0-J79 PDF dumps; HPE0-J79 exam dumps:: https://www.dumpsschool.com/HPE0-J79-exam-dumps.html (60 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)
Latest and Most Accurate HPE0-J79 Dumps Exam Questions and Answers:
Which resource can be used to verity storage system support when using HPE FlexFaDnc 5900CP switches in a solution design’?
A. HPE QuicKSpecs
B. HPE SAN Design Guide
C. HPE Backup. Recovery, and Archive (BURA) Solutions design guide
D. HPE Single Point of Connectivity Knowledge
Which network requirements and HPE best practices must be discussed with a customer before implementing an HPE StoreVirtualmulti-site solution in a 1 GbEenvironment?
A. using as few Gb Ethernet links between sites as possible
B. sharing of the WAN bandwidth between servers
C. need for 50 MB/s of bandwidth on each storage node
D. round top latency of less than 2 ms between sites
E. removal of firewalls. NAT devices, and QoS
Answer: A, D
A customer’s business requires 24×7 uptime and highest data availability. In the past, the customer has experienced revenue loss from several outages during firmware upgrade processes with non-HPE products due to temporary loss of access to disk enclosures. There is a need for 80 TB of Tier-0 storage. You proposes cage availability in the new design, using a 2-node, HPE 3PAR StoreServ containing 80 x 1.92 TB cMLC SSD drives.
When following the HPE best practices, how many additional enclosures should be included in the system?
You are presenting a solution for an HPE 3PAR StoreServ system using 3.84 TB cMLC SSD drives. Which additional value should you focus on to appeal to the interests of the company’s CFO?
A. savings of the solution when compared to 1.92 TB cMLC SSD.
B. savings of the solution when compared to a similar configuration using 10 k SAS drives.
C. performance gain when compared to 1.92 TB cMLC SSD.
D. savings of the solution, which approaches the cost of 15 k SAS drives.
Which requirements must be considered when designing and sizing an HPE 3PAR StoreServ environment for periodic asynchronous replication?
A. Size only the source array to account for the IOPS resulting from snapshot created by Remote Copy.
B. Size both arrays to account for the IOPS resulting from snapshots created by Remote Copy.
C. Use a CPG with SAS drives for Remote Copy snapshots.
D. Size only the target array to account for IOPS resulting from snapshots created by Remote Copy.
E. Use a CPG with nearline drives for Remote Copy snapshots.
Answer: A, E
You are designing a Fibre Channel storage solution for a customer who is currently attaching all hosts through the Ethernet and the TCP/IP protocol. What is an advantage of choosing Fibre Channel over TCP/IP?
A. Less costly networking hardware
B. Support for greater distances
C. Less overhead
D. More robust error correction
New Updated HPE0-J79 Exam Questions HPE0-J79 PDF dumps HPE0-J79 practice exam dumps: https://www.dumpsschool.com/HPE0-J79-exam-dumps.html