Secrets Of Passing Cisco Certified Network Professional Routing and Switching 300-135 Exam Dumps In First Attempt

Our Cisco Certified Network Professional Routing and Switching 300-135 exam practice software continuously assesses your knowledge and determines when you are ready to pass your Cisco 300-135 exam. Our ITsecurityexams’s Cisco 300-135 exam dumps material can assess if there is a gap between your knowledge. We at ITsecurityexams present you latest Cisco 300-135 exam questions with a focused training module that gets you to pass the 300-135 certification Exam.

Vendor Cisco
Exam Code 300-135
Full Exam Name Troubleshooting and Maintaining Cisco IP Networks
Certification Name Cisco Certified Network Professional Routing and Switching
Technology Network Administration

♥ Get Valid 300-135 Exam Questions ♥

300-135 exam questions, 300-135 PDF dumps; 300-135 exam dumps: 300-135 Exam Dumps (177 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-135 Exam Questions:

Version: 15.1
Question: 1

The implementations group has been using the test bed to do a ‘proof-of-concept’ that requires both
Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the
network addressing, routing scheme, DHCP services, NTP services, and FHRP services, a trouble
ticket has been operated indicating that Client 1 cannot ping the 209.65.200.241 address.
Use the supported commands to Isolated the cause of this fault and answer the following questions.
On which device is the fault condition located?

A. R1
B. R2
C. R3
D. R4
E. DSW1
F. DSW2
G. ASW1
H. ASW2

Answer: G

Question: 2

The implementations group has been using the test bed to do a ‘proof-of-concept’ that requires both
Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the
network addressing, routing scheme, DHCP services, NTP services, and FHRP services, a trouble
ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.
Use the supported commands to isolated the cause of this fault and answer the following questions.
The fault condition is related to which technology?

A. NTP
B. Switch-to-Switch Connectivity
C. Access Vlans
D. Port Security
E. VLAN ACL / Port ACL
F. Switch Virtual Interface

Answer: B

Question: 3

The implementations group has been using the test bed to do a ‘proof-of-concept’ that requires both
Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the
network addressing, routing scheme, DHCP services, NTP services, and FHRP services, a trouble
ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.
Use the supported commands to isolated the cause of this fault and answer the following questions.
What is the solution to the fault condition?

A. In Configuration mode, using the interface port-channel 13 command, then configure switchport
trunk allowed vlan none followed by switchport trunk allowed vlan 20,200 commands.
B. In Configuration mode, using the interface port-channel 13, port-channel 23, then configure
switchport trunk none allowed vlan none followed by switchport trunk allowed vlan 10,200
commands.
C. In Configuration mode, using the interface port-channel 23 command, then configure switchport
trunk allowed vlan none followed by switchport trunk allowed vlan 20,200 commands.
D. In Configuration mode, using the interface port-channel 23, port-channel, then configure
switchport trunk allowed vlan none followed by switchport trunk allowed vlan 10,20,200 commands.

Answer: B

Question: 4

The implementations group has been using the test bed to do a ‘proof-of-concept’ that requires both
Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the
network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP
services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping
the 209.65.200.241 address.
Use the supported commands to isolated the cause of this fault and answer the following questions.
What is the solution to the fault condition?

A. R1
B. R2
C. R3
D. R4
E. DSW1
F. DSW2
G. ASW1
H. ASW2

Answer: G

Question: 5

The implementations group has been using the test bed to do a ‘proof-of-concept’ that requires both
Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the
network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP
services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping
the 209.65.200.241 address.
Use the supported commands to isolated the cause of this fault and answer the following questions.
The fault condition is related to switch technology?

A. NTP
B. Switch-to-Switch Connectivity
C. Loop Prevention
D. Access Vlans
E. VLAN ACL Port ACL
F. Switch Virtual Interface
G. Port Security

Answer: D

New Updated 300-135 Exam Questions 300-135 PDF dumps 300-135 practice exam dumps:https://www.dumpsschool.com/300-135-exam-dumps.html

         

Facebook Comments