Cisco Certified Network Professional Routing and Switching 300-115 Exam Dumps – Pass With Guarantee

Our Cisco Certified Network Professional Routing and Switching 300-115 exam practice software continuously assesses your knowledge and determines when you are ready to pass your Cisco 300-115 exam. Our ITsecurityexams’s Cisco 300-115 exam dumps material can assess if there is a gap between your knowledge. We at ITsecurityexams present you latest Cisco 300-115 exam questions with a focused training module that gets you to pass the 300-115 certification Exam.

Vendor Cisco
Exam Code 300-115
Full Exam Name Implementing Cisco IP Switched Networks
Certification Name Cisco Certified Network Professional Routing and Switching
Technology Network Security

♥ Get Valid 300-115 Exam Questions ♥

300-115 exam questions, 300-115 PDF dumps; 300-115 exam dumps: 300-115 Exam Dumps (580 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-115 Exam Questions:

Version: 35.0
Question: 1

Which two VLAN ranges can you add. modify or delete on a switch’? (Choose two)

A. 1 through 1001
B. 1006 through 4094
C. 1005 through 4094
D. 2 through 1001
E. 2 through 4094

Answer: BD

Question: 2

Which Cisco technology provides network redundancy by combining two physically separate
switches to a single logical switch’?

A. VSS
B. IPPS
C. PAGP
D. LACP

Answer: A

Question: 3

Which two commands configure RSPAN to capture incoming and outgoing traffic on a single
interface’? (Choose two)

A. monitor session 1 source interface gigabitethernetl/0/2 tx
B. monitor session 1 destination remote vlan 910
C. monitor session 1 source interface gigabitethernetl/0/1 rx
D. monitor session 1 destination interface gigabitethernetl/0/2 rx
E. monitor session 1 source interface gigabitethernet1/0/2 both

Answer: BE

Question: 4

Which feature is enabled automatically when you configure HSRP on an interface?

A. ICMP redirect messages
B. HSRP tracking
C. IGMP snooping
D. HSRP preemption

Answer: A

Question: 5

Which command do you enter to troubleshoot a misconfigured EtherChannel?

A. CORE-SW(config)#spanning-tree etherchannel guard misconfig.
B. CORE-SW(config-if)#spanning-tree guard root
C. CORE-SW(config-if)#spanning-tree loopguard default
D. CORE-SW(config-if)#spanning-tree etherchannel guard misconfig

Answer: A

Question: 6

Which statement about configuring an RSPAN session is true?

A. RSPAN supports, by default, the monitoring of Layer 2 switch protocols.
B. The same RSPAN VLAN is used for a RSPAN session on all the switches.
C. Only the source switch in a session must support RSPAN
D. At least one access port must be configured in the RSPAN VLAN

Answer: B

New Updated 300-115 Exam Questions 300-115 PDF dumps 300-115 practice exam dumps:https://www.dumpsschool.com/300-115-exam-dumps.html

         

Facebook Comments