Latest Certified Wireless Analysis Professional CWAP-403 Exam Dumps – Secret To Pass

DES-1B21 Exam Questions

Our CWNP Certified Wireless Analysis Professional CWAP-403 exam practice software continuously assesses your knowledge and determines when you are ready to pass your CWNP CWAP-403 exam. Our ITsecurityexams’s CWNP CWAP-403 exam dumps material can assess if there is a gap between your knowledge. We at ITsecurityexams present you latest CWNP CWAP-403 exam questions with a focused training module that gets you to pass the CWAP-403 certification Exam.

Vendor CWNP
Exam Code CWAP-403
Full Exam Name Certified Wireless Analysis Professional (CWAP)
Certification Name Certified Wireless Analysis Professional
Technology

♥ 2019 Valid CWAP-403 Exam Questions ♥

CWAP-403 exam questions, CWAP-403 PDF dumps; CWAP-403 exam dumps: CWAP-403 Exam Dumps (60 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate CWNP CWAP-403 Exam Questions:

Version: 8.0
Question: 1

Which one of the following should be the first step when troubleshooting a WLAN issue?

A. Identify capture locations
B. Identify probable causes
C. Perform an initial WLAN scan and see if any obvious issues stand out
D. Define the problem

Answer: D

Question: 2

Which one of the best following is an advantage of using display filters instead of capture-time
filters?

A. Display filters allow for focused analysis on just the packets of interest
B. Once created display filters are reusable for later captures
C. Display filters only hide the packets from view and the filtered packets can be enabled for view
later
D. Multiple display filters can be applied simultaneously

Answer: A

Question: 3

Using a portable analyzer you perform a packet capture next to a client STA and you can see that the
STA is associated to a BSS. You observe the STA sending packets to the AP and the AP sending packets
to the ST
A. Less the 2% of all packets are retransmissions. You move to capture packets by the AP and, while
the retry rate is still very low, you now only see unidirectional traffic from the AP to the client. How
do you explain this behavior?

A. There is a transmit power mismatch between the client and the AP and while the client can hear
the Aps traffic, the AP cannot hear the client.
B. The portable analyzer has a lower receive sensitivity than the AP and while it can’t capture the
packets from the client STA, the AP can receive them OK.
C. The STA is transmitting data using more spatial streams than the potable analyzer can support
D. The portable analyzer is too close to the AP causing CCI, blinding the AP to the client’s packets

Answer: B

Question: 4

Given a protocol analyzer can decrypt WPA2-PSK data packets providing the PSK and SSID are
configured in the analyzer software.
When performing packet capture (in a non-FT environment) which frames are required in order for
PSK frame decryption to be possible?

A. Authentication
B. Reassociation
C. 4-Way Handshake
D. Probe Response

Answer: C

Question: 5

When configuring a long term, forensic packet capture and saving all packets to disk which of the
following is not a consideration?

A. Total capture storage space
B. Individual trace file size
C. Real-time packet decodes
D. Analyzer location

Answer: B

Question: 6

You are performing a multiple adapter channel aggregation capture to troubleshoot a VoIP roaming
problem and would like to measure the roaming time from the last VoIP packet sent on the old AP’s
channel to the first VoIP packet sent on the new AP’s channel. Which timing column in the packet
view would measure this for you?

A. Delta
B. Absolute
C. Roaming
D. Relative

Answer: C

New Updated CWAP-403 Exam Questions CWAP-403 PDF dumps CWAP-403 practice exam dumps: https://www.dumpsschool.com/CWAP-403-exam-dumps.html

         

Facebook Comments